Table of Contents
Advertisement
3.2 Precautions for Mounting the Battery Holder Unit
Fix the battery holder unit (Q170DBATC) on the panel with screws, paying particular attention to the mounting
location and direction of the unit. The fixing screws (M5 x 14) are to be prepared by user.
(1) Mounting location of the unit
Mount the battery holder unit less than 50cm away from the CNC CPU (as the battery cable is 50cms
long).
(2) Mounting face
Mount the battery holder unit on a flat face.
(3) Mounting direction of the unit
Do not mount the battery holder unit with the bottom up, which may lead the leakage of the battery liquid
when the battery gets broken.
M IT S U B IS H I
LITHIUM BATTERY
(4) Make sure to hold the connector when connecting and removing the cable.
NG
Make sure to insert the connector until it clicks into place, when connecting.
(Note) Carry out wiring so that there is no possibility of short circuit nor dangerous state between wires.
GOOD
CPU
Q170DBATC
BATTERY
3.2 Precautions for Mounting the Battery Holder Unit
NG
C70 Connection Manual
63
Advertisement
Table of Contents
