Connecting The Got - Mitsubishi Electric C70 Connection Manual

MITSUBISHI CNC
4. Wiring and Connecting

4.4 Connecting the GOT

Connect a LAN cable to the connector DISPLAY I/F for the connection of the display module such as
GOT1000 series.
Refer to "GOT1000 Series Connection Manual 1/3" (SH(NA)-080532ENG) for the connection of GOT series.
Ethernet communication module is separately required for GT15.
[GT16]
[GT15]
.
Use the cable, connector and hub that comply the IEEE802.3 100BASE-TX standard.
Cross connection cable is used for one-to-one connection with display module. Straight connection cable is
usually used for the connection through a hub.
Shielded twisted pair cable (STP) is necessary to run a LAN cable out of the control panel. Install a ferrite
core (TDK product, ZCAT3035-1330) around the cable. (Refer to "EMC Installation Guideline: EMC
Countermeasure Parts: Ferrite Core Installation Method" to see how to install the ferrite core.)
Be sure to separate the LAN cable from the drive line, because LAN cables are easily affected by noise.
H200 cable is an unshielded twisted pair cable (UTP), which is a cross connection cable. The cable is
available for one-to-one connection with Q173NCCPU in the same control panel.
<Related items>
Cable drawing: "Cable: H200 Cable"
72
HUB
Q173NCCPU
Cable G303
(100BASE-T STP Straight)
or
Cable H200 (100BASE-T UTP cross)
Cable G302 (100BASE-T STP cross)
HUB
Q173NCCPU
Cable G303
(100BASE-T STP Straight)
or
Cable H200 (100BASE-T UTP cross)
Cable G302 (100BASE-T STP cross)
GOT1000
GOT1000
Ethernet I/F
GT15-J71E71-100