Electric Installation Diagram - La Spaziale COMPACT Instruction Manual For The Installer

1.6

ELECTRIC INSTALLATION DIAGRAM

KEY
1
Main switch (prepared by the customer)
2
Motor pump (if not built in)
When carrying out electric connections, please take into
consideration all warnings and indications provided in
this manual. Furthermore, in order to avoid dangerous
overheating, unwind the power cable completely.
Should the power rating of the installation site not
correspond to the one stated on the machine plate,
change the connections on the heating element and
on the power cable of the machine, following the wiring
diagrams enclosed in this handbook and/or inside the
machine (on the right side).
The appliance cables are marked as follows:
A - Appliance power cable
B - Motor-driven pump cable (if not built in)
a) Connect cable A – (Pict 2) directly to the single-pole switch (1 - Pict 2).
b) Connect cable B - (Pict 2) directly to the motor-driven pump (2 - Pict 2).
Cable B (pict2) is not to be found on appliances fitted with built-in pump.
For the connections in point a), please refer to the wiring diagrams in the chapter "Wiring Diagrams"

for the appliance model being installed.
Connect the yellow/green wire of cable B (pict 2) to the earth terminal pre-fitted to the motor pump
(if not built in).
When making the 400 3 + N connection, connect the blue wire of cable A (pict 2) to the neutral
phase of the system.
CONNECTION DIAGRAM FOR HEATING ELEMENTS AND THE pOWER CABLE IN 400V THREE-
pHASE AppLIANCES
Heating element
connection
Power cable
connection
NOTE: 230V single-phase connections are only possible with rating plate data of 5000 W or lower.

V400/3
Black
Red
Brown
V400/3
N N M A
R S T N
Neutral
Phase
INSTRUCTION MANUAL FOR THE INSTALLER
1
V230/3
Black
Red
Brown
V230/3 V230
N N M A N N A M
R S T F N
Neutral
Phase
Phase
B
A
2
V230
Black
Red
Brown
N = Black
A = Blue
M = Brown
LSI 001 -EN- REV. 06
2
7