Table of Contents
Advertisement
4.3
Removing the Control Tap from the fire.
4.3.1
Remove the burner assembly as in section 4.1.
4.3.2
Pull the control knob off the control tap spindle.
4.3.3
Loosen and remove the two gas pipe retaining nuts from the control
tap and release the ends of the gas pipes from the control tap body.
Remove the screw in thermocouple from the end of the control tap.
4.3.4
Unscrew the control tap locknut from the front of the control panel and
remove the control tap.
4.3.5
To refit a control tap, reassemble in reverse order noting that the control
tap locates with a flat in the control panel. Carry out a gas tightness
test after re-assembly.
4.4
Removing the Oxy-Pilot Assembly
Note : Because this appliance is fitted with an atmosphere sensing 'Oxy-
Pilot' it is not possible to replace the thermocouple separately, because the
thermocouple position is factory set to a tight tolerance. Any replacement of
parts on the pilot requires a complete new pilot assembly.
4.4.1
Remove the burner assembly as in section 4.1
4.4.2
Disconnect the pilot pipe, unscrew and remove the thermocouple
retaining nut from the end of the control tap and disconnect the ignition
lead from the pilot electrode.
4.4.3
Unscrew and remove the two pozi-driv screws which secure the pilot
assembly to the burner. Remove the pilot.
4.4.4
Re-assemble in reverse order and carry out a gas tightness test.
PARTS SHORTLIST
Replacement of any other parts must be carried out by a competent person such
as a CORGI registered gas installer. The part numbers of the main replaceable
parts are as follows, these are available from CFM Europe Ltd. (see rear page for
contact details)
Complete Coal Pack
B-91480
Coal Fuelbed Matrix
B-91500
Coal Fuelbed Front Rail
B-91490
Loose Coal Pack
B-91510
Gas Valve
B-36990
Complete Pebble Pack
Pebble Fuel-bed Matrix
Pebble Fuelbed Front Rail
Loose Pebble Pack
ODS Pilot
24
B-91520
B-91540
B-91530
B-91550
B-38930
Hide quick links:
Advertisement
Table of Contents
