Verify Management Interface Status - Cisco NCS 1002 System Setup And Software Installation Manual

Perform Preliminary Checks
=============================== ================================================
Card Type
=================== ========================== ====== ======= ======== =========
NCS1002
--------------------------------------------------------------------------------
NCS1002
NCS1002--RP
--------------------------------------------------------------------------------
Upgrade all the FPDs using the upgrade hw-module location all fpd all command in the Cisco IOS XR
EXEC mode. After an upgrade is completed, the Status column shows RLOAD REQ if the software requires
reload.
If Reload is Required
If the FPGA location is 0/RP0, use the admin hw-module location 0/RP0 reload command. This command
reboots only the CPU. As a result, traffic is not impacted. If the FPGA location is 0/0, use the admin hw-module
location all reload command. This command reboots the chassis. As a result, traffic is impacted. After the
reload is completed, the new FPGA runs the current version.
If Firmware Upgrade Fails
If the firmware upgrade fails, use the show logging command to view the details and upgrade the firmware
again using the above commands.
Notes for Release 6.1.2
NCS 1002 uses signed images from R6.1.2. Hence, the firmware must be upgraded to identify the signed
images. When the user needs to use the MACsec feature and upgrades from R6.0.1 to 6.1.2, the control FPGA
(CTRL_BKP_UP, CTRL_BKP_LOW, CTRL_FPGA_UP, and CTRL_FPGA_LOW) must be upgraded to
the latest firmware version provided by R6.1.2.

Verify Management Interface Status

To verify the management interface status, perform the following procedure.
Procedure
show interfaces mgmtEth instance
Displays the management interface configuration.
Example:
RP/0/RP0/CPU0:ios# show interfaces MgmtEth 0/RP0/CPU0/0
Wed Feb 28 03:30:35.525 UTC
MgmtEth0/RP0/CPU0/0 is up, line protocol is up
Interface state transitions: 1
Hardware is Management Ethernet, address is 501c.bf10.9fc0 (bia 501c.bf10.9fc0)
Field Programmable Device Package
================================================
FPD Description
CTRL_BKP_LOW
CTRL_FPGA_LOW
CTRL_BKP_UP
CTRL_FPGA_UP
BIOS_Backup
BIOS_Primary
Daisy_Duke_BKP
Daisy_Duke_FPGA
System Setup and Software Installation Guide for Cisco NCS 1002

Verify Management Interface Status

Req SW Min Req
Reload Ver SW Ver
YES 2.23 2.23
YES 2.23 2.23
YES 2.23 2.23
YES 2.23 2.23
YES 14.00 14.00
YES 14.00 14.00
YES 0.15 0.15
YES 0.17 0.17
Min Req
Board Ver
0.1
0.1
0.1
0.1
0.1
0.1
0.1
0.1
27