Cisco NCS 1002 System Setup And Software Installation Manual page 29

Perform Preliminary Checks
0/PM0
0/PM1
Displays the firmware information of various hardware components of the NCS 1002 in the Cisco IOS XR
EXEC mode.
In the above output, some of the significant fields are:
• FPD Device—Name of the hardware component such as FPD, CFP, and so on.
• ATR—Attribute of the hardware component. Some of the attributes are:
• Status— Upgrade status of the firmware. The different states are:
• Running—Current version of the firmware running on the FPD.
Step 2
show hw-module slice slice_number
Displays the slice and Datapath FPGA (DP-FPGA) information of the NCS 1002.
Example:
RP/0/RP0/CPU0:ios# show hw-module slice 0
Wed Feb 28 04:01:45.828 UTC
Slice ID:
Status:
Client Bitrate:
Trunk Bitrate:
DP FPGA FW Type:
DP FPGA FW Version:
HW Status:
Encryption Supported:
LLDP Drop Enabled:
Client Port -
Traffic Split Percentage
NCS1K-2KW-AC 0.0
NCS1K-2KW-AC 0.0
• B—Backup Image
• S—Secure Image
• P—Protected Image
• CURRENT—The firmware version is the latest version.
• READY—The firmware of the FPD is ready for an upgrade.
• NOT READY—The firmware of the FPD is not ready for an upgrade.
• NEED UPGD—A newer firmware version is available in the installed image. It is recommended
that an upgrade be performed.
• RLOAD REQ—The upgrade has been completed, and the ISO image requires a reload.
• UPGD DONE—The firmware upgrade is successful.
• UPGD FAIL— The firmware upgrade has failed.
• BACK IMG—The firmware is corrupted. Reinstall the firmware.
• UPGD SKIP—The upgrade has been skipped because the installed firmware version is higher than
the one available in the image.
0
Provisioned
10
100
XMG1
01.01
CURRENT
FALSE
FALSE
Trunk Port
PO-PriMCU CURRENT
PO-PriMCU CURRENT
CoherentDSP0/0/0/5
System Setup and Software Installation Guide for Cisco NCS 1002
Verify Firmware Version
4.00 4.00
4.00 4.00
CoherentDSP0/0/0/6
25