Perform Preliminary Checks; Verify Status Of Hardware Components - Cisco NCS 1002 System Setup And Software Installation Manual

Perform Preliminary Checks

After successfully logging into the console, you must perform some preliminary checks to verify the default
setup. If any setup issue is detected when these checks are performed, take corrective action before making
further configurations. These preliminary checks are:
•
•
•
•
•
•
•
•

Verify Status of Hardware Components

To verify the status of all the hardware components installed on the NCS 1002, perform the following
procedure.
Before you begin
Ensure that all the required hardware components have been installed on the NCS 1002. For installation details,
see Cisco Network Convergence System 1000 Series Hardware Installation Guide.
Procedure
Step 1
show platform
When you execute this command from the Cisco IOS XR EXEC mode, the status of the Cisco IOS XR is
displayed.
Verify that the node state is Operational and admin state is UP.
Example:
RP/0/RP0/CPU0:ios# show platform
Wed Feb 28 03:28:40.004 UTC
Node
Verify Status of Hardware Components, on page 17
Verify Node Status, on page 21
Verify Software Version, on page 23
Verify Firmware Version, on page 24
Verify Management Interface Status, on page 27
Verify Alarms, on page 29
Verify Environmental Parameters, on page 30
Verify Inventory, on page 33
Type
C H A P T E R
State
System Setup and Software Installation Guide for Cisco NCS 1002
3
Config state
17