Fpd Automatic Upgrade - Cisco NCS 1002 System Setup And Software Installation Manual

FPD Automatic Upgrade

sysadmin-vm:0_RP0# show hw-module fpd
Wed Feb
Location
-------------------------------------------------------------------------------
0/0
0/0
0/0
0/0
0/RP0
0/RP0
0/RP0
0/RP0
0/PM0
0/PM1
FPD Automatic Upgrade
FPD automatic upgrade feature upgrades the FPD firmware version of all the components to the latest version
along with software activation. After the software upgrade, all the FPD components are in CURRENT status,
which can be checked using the
Once the FPD is upgraded, the FPD version is not downgraded to the previous version even if the image is
rolled back to the original version.
You can enable the FPD automatic upgrade feature using the following commands.
RP/0/RP0/CPU0:ios# conf
RP/0/RP0/CPU0:ios(config)# fpd auto-upgrade enable
RP/0/RP0/CPU0:ios(config)#commit
RP/0/RP0/CPU0:ios(config)#end
To verify if the FPD automatic upgrade feature is enabled, examine the output of the show running-config
command.
RP/0/RP0/CPU0:ios#
RP/0/RP0/CPU0:ios#show running-config | inc fpd
Thu Jul 5 15:42:02.502 IST
Building configuration...
fpd auto-upgrade enable
Example
The following example shows how to enable the FPD automatic upgrade feature.
RP/0/RP0/CPU0:ios#conf
RP/0/RP0/CPU0:ios(config)#fpd auto-upgrade enable
RP/0/RP0/CPU0:ios(config)#commit
RP/0/RP0/CPU0:ios(config)#end
The following example shows the output of show running-config command after enabling the FPD automatic
upgrade feature.
RP/0/RP0/CPU0:ios#
RP/0/RP0/CPU0:ios#show running-config | inc fpd
Thu Jul
Building configuration...
fpd auto-upgrade enable
System Setup and Software Installation Guide for Cisco NCS 1002
60
28 03:35:09.566 UTC
Card type HWver FPD device
NCS1002-K9 0.1
NCS1002-K9 0.1
NCS1002-K9 0.1
NCS1002-K9 0.1
NCS1K-CNTLR 0.1
NCS1K-CNTLR 0.1
NCS1K-CNTLR 0.1
NCS1K-CNTLR 0.1
NCS1K-2KW-AC 0.0
NCS1K-2KW-AC 0.0
show hw-module fpd
5 15:42:02.502 IST
Perform System Upgrade and Install Feature Packages
ATR Status
CTRL_BKP_LOW B CURRENT
CTRL_BKP_UP B CURRENT
CTRL_FPGA_LOW CURRENT
CTRL_FPGA_UP CURRENT
BIOS_Backup BS CURRENT
BIOS_Primary S CURRENT
Daisy_Duke_BKP BS CURRENT
Daisy_Duke_FPGA S CURRENT
PO-PriMCU CURRENT
PO-PriMCU CURRENT
command.
FPD Versions
===============
Run Programd
2.23
2.23
2.23 2.23
2.23 2.23
14.00
14.40 14.40
0.15
0.17 0.17
4.00 4.00