Performing Firmware Update With Micro Sd Card (3Rw5 Hmi High Feature) - Siemens SIRIUS 3RW5 Manual

8.1.1

Performing firmware update with micro SD card (3RW5 HMI High Feature)

Requirements
● Micro SD card with valid firmware file (*.upd)
You will find more information and requirements for supporting the micro SD card in the
Equipment Manual of the 3RW5 soft starter.
● The valid firmware file is located in the root directory (topmost level).
● You are in the "micro SD card > FW Update" menu.
Procedure
Note
Access to micro SD card.
Please note that the micro SD card is inserted in the 3RW5 HMI High Feature during
updating of the firmware.
Premature removal of the micro SD card from the 3RW5 HMI High Feature is not permissible
and will terminate updating of the firmware. Data could also be lost.
1. Select the folder of the respective device.
2. Select the firmware file of the device and confirm with "OK".
You can see the firmware update is being performed from the progress bar on the
display.
Following successful updating of the firmware, the respective device then restarts
automatically.
Note
Firmware update of the 3RW5 HMI High Feature:
Please note that the display switches off for about 30 seconds when the firmware is
activated.
3. Check the new firmware version in the "Overview" menu.
Result
You have performed a firmware update for the selected device using the micro SD card.
More information
You will find more information on operating the 3RW5 HMI High Feature in the
Equipment Manual of the 3RW5 soft starter.
SIRIUS 3RW5 EtherNet/IP communication module
Manual, 05/2019, A5E45131885002A/RS-AA/001
Maintenance and service
8.1 Firmware update
61