Initial Setup - mangOH Red User Manual

Rev 2 May.17

Initial Setup

To begin using the mangOH Red, set up your hardware and software:
1. Insert a supported CF3 module in the socket. See
Module on page 11.
2. Select Primary Power
3. If you will be establishing a mobile network connection, insert a micro-SIM. See
Inserting a micro-SIM Card
4. Connect Antenna(s). See page 17.
5. Install / Update Windows
6. Make sure SW401 pin 1 is ON. This allows the module to power up as soon as
power is supplied. (If SW401 pin 1 is OFF, you must press SW402 after power is
supplied to power up the module.)
1
Figure 2-3: Check SW401 Pin 1 Position
7. Power up the mangOH Red—Plug one end of a micro-USB cable into the
mangOH Red USB connector that you selected as the power supply in
and plug the other end into your computer or an AC adapter.
Note: If the mangOH Red is powered from an AC adapter, choose the appropriate
micro-USB connector:
• Console—This leaves the CF3 connector available to access the CF3 module's ECM
port, issue AT commands, and download firmware updates to the Wi-Fi/BT (MediaTek
Wi-Fi+Bluetooth) chipset.
• CF3 USB—This leaves the Console connector available to access the consoles of the
CF3 module or Wi-Fi/BT chipset (switch-selectable), and to download firmware updates to
the CF3 module.
If you connected the cable to the correct micro-USB slot, the power LED on the
top side of the mangOH Red turns on.
8. Use a second mini-USB cable to connect the remaining mangOH Red USB
connector (CF3 USB or Console) to your computer.
9. Install a Terminal Emulator. See page 35.
Supply. See page 15.
on page 19.
Driver. See page 34.
9
Setup and Installation
Insert/Remove Embedded
1—SW401 pin 1
2—SW402
Step 2
41110400
2