Table of Contents
Advertisement
mangOH Yellow User Guide
2.3 Initial Setup
To begin using the mangOH Yellow, set up your hardware and software:
1. Verify the SW403 dip switch block pins are set correctly:
a. Remove the protective film from the dip switch block:
Figure 2-2: Remove Protective Film
b. Make sure all the dip switches are OFF (factory default mode).
Figure 2-3: Dip Switch Positions (Factory Default)
2. If you will be establishing a mobile network connection using the external SIM slot instead of the WP7702
module's eSIM, insert a micro-SIM. See
3.
Connect External
Antenna(s). See page 15.
4.
Select Power
Supply. See page 13.
Rev 2 10/21/19
Inserting a micro-SIM Card
8
Remove this film
on page 16.
41113427
Advertisement
Table of Contents
