mangOH Red User Guide
Rev 2 May.17
Figure 3-18: microSD—Inserted
Inserting/Removing an IoT Expansion Card
The mangOH Red includes one IoT Expansion Card slot.
Caution:
Handle IoT Expansion Cards carefully to make sure components are not accidentally
damaged. Hold them by their edges to avoid possible ESD damage.
To install an IoT Expansion Card:
1. Remove power from the mangOH Red (disconnect the micro-USB cable from the
computer or AC adapter).
Note: You must remove the power because IoT Expansion Cards are not hot-
swappable—the card will be recognized when power is reapplied.
2. Check the expansion card to make sure you know which side is the top.
(Expansion cards must not be inserted upside-down.)
3. Slide the expansion card straight into the IoT Connector (CN306).
4. Use two M2 screws (included) to secure the expansion card to the standoffs.
Figure 3-19: IoT Expansion Card Insertion
22
41110400