Sim, Sd, And Iot Expansion Cards; Inserting A Micro-Sim Card - mangOH Red User Manual

Rev 2 May.17

SIM, SD, and IoT Expansion Cards

Inserting a micro-SIM Card

To establish a mobile network connection with a CF3 module, you must install a
micro-SIM in the connector on the bottom side of the mangOH Red. Use either of the
following:
• Live SIM card with active account (e.g. the Sierra Wireless SIM provided with the
kit, or another carrier's activated card), or
• Test SIM card for use with a call box (for example, an Agilent 8960 or
Rohde & Schwarz CMU200)
To install a SIM card:
1. Place the Dev Kit face-down (as shown).
1—micro-SIM (CN600—bottom)
2—micro-SD (CN600—top)
Figure 3-13: SIM Connector and micro-SD Locations
2. Insert the SIM card with contacts face-down into the desired slot—note the
location of the notched corner of the card in
Important:
CN600 is a dual-connector—the lower slot is for the micro-SIM, and the
upper slot is for a microSD card.
Figure
19
Hardware Setup and Features
2
1
3-14.
41110400