mangOH Red User Guide
Rev 2 May.17
Physical Switches
Reset Switches
The mangOH Red includes two reset switches:
•
Board reset (SW400)—Press and hold for 5 seconds to reset the board.
Note: When the board is resetting, the reset signal is held LOW until the CF3 module is
fully booted.
•
ULPM/PWR_ON (SW402)—If SW401 pin 1 (PWR_ON) is:
· Off—When power is connected to the board, press and release SW402 to
power on the module. After the module powers on, SW402 has no effect.
· On—When power is connected to the board, power is supplied automatically to
the module. SW402 has no effect.
For details on resetting the mangOH Red or specific application blocks, see the
mangOH Red Developer's Guide.
1
Figure 3-28: Reset Switches
Buttons
The mangOH Red includes one generic button (SW200) for user-defined purposes.
1—Board reset (SW400)
2—ULPM/PWR_ON (SW402)
3—Generic switch (SW200)
28
2
3
41110400