mangOH Red Getting Started
Rev 2 8/23/17
3.2 Hardware Setup
To set up the mangOH Red board:
1. Insert the CF3 module—Hold the module above the socket and line up the
triangles on the module and socket. The module will drop straight into the socket.
(Position matters!)
2. Hold the module cover over the module and line up the circle on the cover with
the triangle on the label, then press the cover (on the edges) into place.
10
The triangle on the label
matches the position of the
circle on the cover.
The triangle on the label
matches the position of the
triangle on the socket.
41110481