Connect Battery Backup - mangOH Red User Manual

mangOH Red User Guide
Rev 2 May.17
1—Console USB select (left + center pins)
Figure 3-8: Power Source Select (Console USB select shown)

Connect Battery Backup

Optionally, you can connect a rechargeable Li-Ion/Li-Polymer battery to the
mangOH Red to provide uninterrupted power in the event that the primary power
supply fails.
If SW401 pin 5 is ON, the mangOH Red recharges the battery and then provides a
trickle charge to maintain the battery's full charge.
To connect a rechargeable Li-Ion/Li-Polymer battery to the mangOH Red:
1. Connect the battery to CN802.
1—Recharge select (SW401, pin 5)
2—Rechargeable battery connector (CN802)
Figure 3-9: Battery Backup Connector
2. If you want the battery to recharge while connected to the board, set switch
SW401 pin 5 to ON.
2—CF3 USB select (center + right pins)
16
1
2
41110400