Table of Contents
Advertisement
Rev 2 May.17
4. Attach the module cover:
a. Hold the module cover above the CF3 module and line up the polarity marks
on the module and cover.
Figure 3-4: Installing Module Cover
b. Place the cover on the module, then press down carefully until you hear the
cover click into place. Make sure all sides of the cover have clicked into place.
Figure 3-5: Module Cover Installed
To remove a CF3 module:
1. Remove the module cover using the module cover removal tool—Starting at one
corner, insert the tool in the pair of holes and carefully pry the cover away from
the module.
2. Repeat at the other locations (pairs of pry holes are on each side).
13
Hardware Setup and Features
41110400
Advertisement
Table of Contents
