Checking The Network-Connection; Troubleshooting - Fujitsu MB91460 Getting Started

Chapter 7 Setup / Change Connection PC – Emulation System
„the unique IP address (as set by LAN-Address, see above)"
of emulator"
e.g.
141.187.6.82
141.187.6.82
When saving again the file Imhosts get sure that your editor (e.g. notepad) will
not add any extension, e.g. .txt, to your file. To get sure, use quotation marks
for the filename:
e.g. File save as:"lmhosts" (or lmhosts.sam)

7.3.4 Checking the network-connection

Disconnect serial RS232 (or USB) cable from Emulator and try to find the emulator:
• Open DOS-Window (or open RUN (Ausführen) in the Start-Menu)
• The command
that means the network is set up right.
The emulator with LAN-adapter is successfully integrated in the network environment
and can be used by the Softune Workbench.

7.3.5 Troubleshooting

If the command
ping my_emulator
emulator by its IP-address: Type command
.
141.187.6.82
If this will work, then check settings (nickname and IP-address) within Imhosts and
Hosts.
If neither nickname (my_emulator) nor IP-address will work, check settings done
by the program LAN-address and check the file Services.
MCU-AN-391005-E-V17
Getting Started
Figure 26: Edit the File Imhosts.asm
fjicescv
Emulator
should acknowledge with some time-values,
ping Emulator
will reply with a timeout-message, try to find the
- 38 -
, e.g.
ping IP-address
© Fujitsu Microelectronics Europe GmbH
„nickname
ping