Mounting The Evaluation Mcu - Fujitsu MB91460 Getting Started

4.3.2 Mounting the Evaluation MCU

1. Press down the top of the IC socket. Take care when you press the IC socket; Hold
the board against the pressure not to bend the board.
2. Confirm that the hook is open, and put the evaluation MCU on the socket. The index
shows the A1 pin of the evaluation MCU.
3. Release the socket slowly and confirm that the evaluation MCU is fastening to the
socket.
The following figure shows the socket of the evaluation MCU MB91V460.
© Fujitsu Microelectronics Europe GmbH
Getting Started
Chapter 4 Installation of the Emulation System
Figure 3: Mounting the Evaluation MCU
- 11 - MCU-AN-391005-E-V17