Table of Contents
Advertisement
N
Carefully read through the following safety instructions before putting the
Analyzer into operation. Observe all the precautions and warnings provided
in this Manual for all the phases of operation, service, and repair of the
Analyzer.
The Analyzer must be used only by skilled and specialized staff or thoroughly
trained personnel with the required skills and knowledge of safety
precautions.
A434L complies with INSTALLATION CATEGORY II as well as POLLUTION
DEGREE 2 in IEC61010–1.
A434L is MEASUREMENT CATEGORY I (CAT I). Do not use for CAT II, III, or
IV.
A434L is for INDOOR USE only.
A434L is tested in stand-alone condition or in combination with the
accessories supplied by GS INSTRUMENTS CO., LTD. against the
requirement of the standards described in the Declaration of Conformity. If
it is used as a system component, compliance of related regulations and
safety requirements are to be confirmed by the builder of the system.
Never operate the Analyzer in the environment containing inflammable
gasses or fumes.
Operators must not remove the cover or part of the housing. The Analyzer
must not be repaired by the operator. Component replacement or internal
adjustment must be performed by qualified maintenance personnel only.
Never operate the Analyzer if the power cable is damaged.
Never connect the test terminals to mains.
7
Advertisement
Table of Contents
