Table of Contents
Advertisement
System temperature
Model / Serial Number
IP Address Info
The System key opens the following screen menu:
Upgrade: Upgrades the firmware of the instrument. For detailed
upgrade procedure, refer to the section "5.Software Upgrade".
Beep: Activates or deactivates the beep sound when keys are
pressed.
Sweep Mode: Sets the sweep mode either single or continuous in
VSWR, DTF, or Cable Loss measurements. If Sweep Mode is set
Single, the message "Hold On" is displayed at the completion of a
current sweep and the sweep stops. Every time the Hold key is
pressed, the sweep is done once.
Figure 3.5 System Status Screen
59
Advertisement
Table of Contents
