Safety Instructions - Protek A334M User Manual

SAFETY INSTRUCTIONS

SAFETY INSTRUCTIONS
Carefully read through the following safety instructions before putting the
analyzer into operation. Observe all the precautions and warnings provided in this
Manual for all the phases of operation, service, and repair of the analyzer.
The analyzer must be used only by skilled and specialized staff or thoroughly
trained personnel with the required skills and knowledge of safety precautions.
A334M is tested in stand-alone condition or in combination with the accessories
supplied by GS INSTRUMENTS CO., LTD. against the requirement of the standards
described in the Declaration of Conformity. If it is used as a system component,
compliance of related regulations and safety requirements are to be confirmed by
the builder of the system.
Never operate the analyzer in the environment containing inflammable gasses or
fumes.
Operators must not remove the cover or part of the housing. The analyzer must
not be repaired by the operator. Component replacement or internal adjustment
must be performed by qualified maintenance personnel only.
Never operate the analyzer if the power cable is damaged.
Never connect the test terminals to mains.
Electrostatic discharge can damage your product when connected or
disconnected from the DUT. Static charge can build up on your body and damage
the sensitive circuits of internal components of both the product and the DUT.
To avoid damage from electric discharge, observe the following:
 Always use a desktop anti-static mat under the DUT.
 Always wear a grounding wrist strap connected to the desktop anti-static mat
via daisy-chained 1 MΩ resistor.
Observe all the general safety precautions related to operation of equipment
powered by mains.
© 2015 GS Instruments, Co., Ltd
5