Maintenance - Dake 972210 Owner's Manual

operation on the next part. There is no need to raise the ram all the way to the top each
time.
If pressing application requires a certain tonnage, press until the gauge reads the
appropriate tonnage then stop. Release pressure and repeat operation.
NOTE: Never pump the ram down fully and dead head the ram in the cylinder. Only build
pressure when using the table plates or a part is being pressed. Failure to do this may cause
ram seal damage and leaking.
If the application requires off center pressing, loosen the head ram traverse plate bolts and
slide head left or right to the area where pressing is required. You may now proceed with the
operation. When head is returned to the center position snug these bolts up to prevent
unexpected movement.
6. MAINTENANCE OF MACHINE

MAINTENANCE!

1. On a regular basis wipe the entire press. Keep ram free from
debris and abrasive materials (Frequency depends on
environment the machine is in)
2. A light oil applied to the ram will help to keep the surface clean.
3. If the hydraulic hose or table pins are worn or cut, or damaged in
any way, have it replaced immediately.
4. If oil is ever needed, remove plug from the top of the pumping unit
and add hydraulic jack oil. Bleed the system by pumping the
handle repeatedly about a dozen times with the valve open. Close
valve and check that air has been bled.
5. WARNING: Never make adjustments to the pressure setting
adjustment. Never remove the red plastic cap covering this
adjustment screw. Serious machine damage or physical injury
may occur.
Always make sure you are
pressing with the whole ram.
Center ram over the work, do
not press with only the edge
of the nose piece. This can
cause injury by ejecting the
part, or damage to the ram.
10