Assembly Instructions - Dake 972210 Owner's Manual

STEP 2. Floor models: (Bench model skip this step)
Install the diagonal support straps. Using 4 M8 x 25mm bolts, nuts and washers. Install the
support straps to the inside of the base angles then to the frame as shown. Finger tighten.
Diagonal support
straps
STEP 3:
Carefully stand the unit upright. Making sure all components are square to each other,
tighten all nuts and bolts securely.
STEP 4: Floor model: (Bench model skip this step)
Install pump mounting plate on the side of the upright channel using the 3 M10 x 25mm
bolts, nuts and washers.
STEP 5:
(20-ton model skip this
step, plate is pre-installed).
Mount Head ram traverse
plates. The side with two
Pump mounting plate
bars welded to them go
inside the frame, with
Mounting bolts, nuts, washers
the thick threaded
plate on the bottom.
Using two 10mm x 120
mm bolts, washers and
nuts snug only enough
To allow plate to travel
STEP 6. Floor models: (Bench model skip this step)
Install the pumping unit to the mounting plate using 2 M10 x 25mm bolts, nuts and washers.
Make sure pump is centered on this mounting plate.
Pumping unit
7