Table of Contents
Advertisement
Operating Temperature
After the machine has been operating at full rate check that the oil temperature does not exceed
140°F. If it does exceed 140°F check that the oil used is not too viscous and replace with more
suitable oil if this is the case.
MAINTENANCE
Routine maintenance operation must be carried out by authorized and trained personnel.
All maintenance or cleaning operations must be done with the machine properly locked out in
accordance with OSHA regulations.
− Below is a table the normal times for maintenance work. In addition the work area and press
needs to be cleaned and cleared of material.
Operating
Check oil filter
Hours
50
100
300
500
1000
1500
2000
Changing Oil
The oil will need to be routinely changed every 2000 operating hours or at least once a year. Empty
the until tank be arranging a container of adequate capacity to contain the quantity of old oil being
removed under the drainage plug at the bottom of the tank.
Remember to tighten the plug before refilling the tank with new clean, filtered oil.
Disposing of the oil will have to be done in conformity with local and state laws along with OSHA
regulations. Hydraulic oil is considered a special waste.
Filters
The filter must be frequently replaced during the first period of operating the press and them at
regular intervals of time to be defined according to the conditions of use and the environment where
the machine is located. After that replacement is needed every 500-600 hours.
Check oil
X
X
X
X
X
Press Model
40 ton
70 ton
100 ton
150 ton
Change oil
Change oil filter
X
Oil required
10.5 gallons
10.5 gallons
15.5 gallons
22.5 gallons
13
Dake Corporation
1809 Industrial Park Dr
Grand Haven, MI 49417
www.dakecorp.com
Change air filter
X
X
X
X
X
X
X
X
X
REV122020
Advertisement
Table of Contents
