Execution Of User Program - Hitachi SJ700-2 Series Instruction Manual

3-phase power
supply
(200 or 400 V)
PRG (setting
unchangeable)
Selecting MI1 → X (00)
Selecting MI2 → X (01)
Selecting MI3 → X (02)
Selecting MI4 → X (03)
Selecting MI5 → X (04)
Selecting MI6 → X (05)
Selecting MI7 → X (06)
Selecting MI8 → X (07)
XA (00)
Three
XA (01)
analog input
terminals
XA (02)
Input and output terminals available for general-purpose input/output settings

2.7 Execution of User Program

After downloading the user parameters to the inverter, enable the easy sequence function (by setting "01"
in parameter "A017") to make the inverter ready for program execution. At the same time, the FW terminal
is switched to the PRG terminal. (The FW terminal will no longer function as the terminal to input the
forward-rotation command.) Then, turn on the PRG terminal to execute the user program downloaded to
the inverter.
Chapter 2 Creation and Execution of a User Program
SJ700 Series
Ｒ
Ｓ
Ｔ
ＦＷ
１
２
３
４
５
６
７
８
ＣＭ１
Ｈ
0 to 10V
Ｏ
0 to 10V
Ｏ２
4 to 20mA
ＯＩ
Ｌ
Ｕ
Ｖ
Ｗ
Selecting MO1 → Y (00)
１１
Selecting MO2 → Y (01)
１２
Selecting MO3 → Y (02)
１３
Selecting MO4 → Y (03)
１４
Selecting MO5 → Y (04)
１５
ＣＭ２
ＡＬ０
ＡＬ１
Selecting MO6 → Y (05)
ＡＬ２
ＦＭ
ＣＭ１
ＡＭ
ＡＭＩ
Ｌ
2 - 5
ＩＭ
Five digital
output terminals
One relay
output terminal
Selecting YA0 → YA (00)
Three analog
output
Selecting YA1 → YA (01)
terminals
Selecting YA2 → YA (02)