Installing And Uninstalling Ezsq; Installing Ezsq - Hitachi SJ700-2 Series Instruction Manual

1.1 Installing and Uninstalling EzSQ

1.1.1 Installing EzSQ

This section explains how to install the easy sequence programming software EzSQ.
(1) Insert the EzSQ installation CD-ROM into the CD-ROM drive of your personal computer.
(2) With the CD-ROM drive in auto-starting mode, opening the "Select the Setup Language" window
automatically starts up the EzSQ Installer.
Select "English(U.S)" and click the [OK] button.
Note: If the CD-ROM drive is not in auto-starting mode, perform one of the following three operations to
start up the EzSQ Installer:
1) Start Microsoft Explorer, browse the files on the CD-ROM drive, and then select and open the
"setup.exe" file.
2) Select "Run" from the "Start" menu of Windows. Click the [Browse] button in the "Run" dialog box to
open the "Browse File" dialog box, select "setup.exe" among the files on the CD-ROM drive, and
then click the [Open] button.
3) Select "Run" from the "Start" menu of Windows. Enter "Q:¥setup.exe" in the "File name" field of the
"Run" dialog box, and then click the [OK] button.
("Q" in the file name indicates the CD-ROM drive name that varies depending on the personal
computer.)
(3) The above operation starts up the EzSQ installation wizard ("EzSQ - InstallShield Wizard").
Click the [Next] button as instructed in the wizard window.
1 - 1
Chapter 1 Introduction