Mitsubishi Electric M80 Series Maintenance Manual page 147

M800/M80/E80 Series Maintenance Manual
4 Failure Diagnosis
Menus
Menus
Displays the servo unit diagnosis information in the data display area.
Servo
unit
Displays the spindle unit diagnosis information in the data display area.
Spindle
unit
<Note>
When the parameter "#1039 spinno" is set to "0", this menu is not displayed.
Switches the display between the DA output and the spindle PLG diagnosis information.
PLG
Pressing this button again after this menu is highlighted, the display switches to the DA output.
diagn
<Note>
When the parameter "#1039 spinno" is set to "0", this menu is not displayed.
Even when the parameter "#1039 spinno" is set to other than "0", this menu will be grayed out and
non-selectable. while displaying the servo unit diagnosis information.
This clears the number of alarms of the axis at the cursor position to "0".
All
num clr
This clears the number of alarms at the cursor position to "0".
Alarm
num clr
<Note>
When the cursor is on "AL cause cnt accu" or "freq", this menu is grayed out and non-selectable.
Clears the all values of "AL cause cnt accu" and "freq" of the axis where the cursor is placed to 0.
All
cnt clr
Displays the data of four axes from the next axis.
Next
This menu is displayed only when there are five or more servo axes or spindle.
axis
IB-1501273-F
Details
120