Setting The Inverter; Dc Battery Type - Ingeteam INGECON SUN STORAGE 1Play Technical Manual

4 Setting the inverter

This chapter describes how to configure the inverter settings when the ISS 1Play has been wired to the BYD
B-Box HV battery.
To do so, once all the previous steps have been completed, the following steps must be followed:
1) Make sure that the battery circuit breaker is in OFF position.
2) Disconnect the CAN communication wire from the BYD battery. For that, J2 connector from BYD
should be removed.
3) Move the circuit breaker to ON position to turn the battery pack on.
4) After a few seconds the inverter should get powered. Make sure that the display´s screen is ON.

4.1 DC Battery type

Please be careful to choose the right battery type when you set up the configuration in
your inverter. The battery or inverter manufacturers have no responsibility on the
damages caused due to incorrect configurations. For instance, if you select "Lead-acid"
as a battery type in the inverter configuration and the battery being used is "Lithium-ion",
the battery might get damaged or experience performance degradation.
It is required to set the DC Battery type: BYD B-BOX H5.1/6.4
To configure the battery type in the inverter settings, please NOT connect the CAN communication
wire yet. The communication wire should be connected when the battery type is configured correctly.
This can be done using the "Ingecon Sun Manager" software package (downloadable on www.ingeteam.com)
or through the display:
Using Ingecon Sun Manager:
Settings
Click on the "Send" button. A screen informing that the configuration was successfully saved must appear
when the settings are correctly applied to the inverter.
Using the Display:
To perform any configuration change through the display, the required installer password must be entered on:
The password is indicated on the "Installation and Operation Manual", on the chapter dedicated to
configuration.
When the permission is given, go to:
MAIN MENU > CONFIGURATION > BATTERY > LITHIUM > BYD HV > BYD B-BOX H5.1/6.4
Confirm the desired selection by pressing the "OK" button. A message to confirm the modification will pop up.
A final screen that shows that the process has been completed will be shown on the display.
Technical Guide
1-.DC BATTERY TYPE: Type of Battery > Lithium: BYD B-Box H5.1/6.4
Figure 1: DC Battery selection on Ingecon Sun Manager.
MAIN MENU > CONFIGURATION > ENTER PASSWORD
11/04/2019
INGECON SUN STORAGE 1Play
6/8