Setting The Inverter; Dc Battery Type - Ingeteam INGECON SUN STORAGE 1Play 3TL Manual

Use and settings of the iss 1play working with pylontech force h1/h2 and powercube x1/x2
Hide thumbs Also See for INGECON SUN STORAGE 1Play 3TL:
Table of Contents

Advertisement

5 Setting the inverter

This chapter describes how to configure the inverter settings when the ISS 1Play has been wired to the
Pylontech battery.
To do so, once all the previous steps have been completed, the following steps must be followed:

5.1 DC Battery type

Please be careful to choose the right battery type when you set up the configuration in
your inverter. The battery or inverter manufacturers have no responsibility on the
damages caused due to incorrect configurations. For instance, if you select "Lead-acid"
as a battery type in the inverter configuration and the battery being used is "Lithium-ion",
the battery might get damaged or experience performance degradation.
It is required to set the DC Battery type: Pylontech Force H1/H2 or Powercube X1/X2
This can be done using the "Ingecon Sun Manager" software package (downloadable on www.ingeteam.com)
or through the display:
Using Ingecon Sun Manager:
Settings
1-.DC BATTERY TYPE: Type of Battery > Lithium: Pylontech Force H1/H2
Settings
1-.DC BATTERY TYPE: Type of Battery > Lithium: Pylontech Powercube X1/X2
Click on the "Send" button. A screen informing that the configuration was successfully saved must appear
when the settings are correctly applied to the inverter.
Using the Display:
To perform any configuration change through the display, the required installer password must be entered on:
The password is indicated on the "Installation and Operation Manual", on the chapter dedicated to
configuration.
When the permission is given, go to:
MAIN MENU > CONFIGURATION > BATTERY > LITHIUM > PYLONTECH HV > FORCE H1/H2
MAIN MENU > CONFIGURATION > BATTERY > LITHIUM > PYLONTECH HV > POWERCUBE X1/X2
Confirm the desired selection by pressing the "OK" button. A message to confirm the modification will pop up.
A final screen that shows that the process has been completed will be shown on the display.
Technical Guide
Figure 1: DC Battery selection on Ingecon Sun Manager.
MAIN MENU > CONFIGURATION > ENTER PASSWORD
30/09/2019
or
or
INGECON SUN STORAGE 1Play
7/9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ingecon sun storage 1play 6tl

Table of Contents