Setting The Battery Pack; Web Interface Of Battery - Ingeteam INGECON SUN STORAGE 1Play Technical Manual

3 Setting the battery pack

This chapter describes how to configure the battery settings when the ISS 1Play has been wired to the BYD
B-Box H5.1/6.4 battery.
To do so, once all the previous steps have been completed, the following steps must be followed:
1) Make sure that the battery circuit breaker is in OFF position.
2) Move the circuit breaker to ON position to turn the battery pack on.
3) After a few seconds the inverter and battery should get powered. Make sure that the display´s screen
is ON.
4) Enter in the WEB interface of battery with your PC. For further details, check the "Installation Manual
of BYD HV".

3.1 WEB interface of battery

The inverter type should be configured in the WEB interface. Through the wizard you can configure:
Type of the inverter as "INGETEAM"
Series Battery Counts should be 4 modules for B-Box H5.1 or 5 modules for B-Box H6.4 type.
Technical Guide 11/04/2019
INGECON SUN STORAGE 1Play
5/8