Etna And Derby 9 / Derby 14; Dover; Valencia - Bronpi OXFORD Installation, Operating And Servicing Instructions

2.1.5.

ETNA AND DERBY 9 / DERBY 14

The models Etna, Derby 9 and Derby 14 have a door on the right side whose function is to load fuel (see drawing D30).
In the Etna stove, it is included a handle to remove the ash pan which is hidden behind the lower door (see drawing D31).
In the model Etna the handle of the side door is type "cold hands", it is advisable to remove the handle in order to avoid its heating and
deterioration.
D30
2.1.6.

DOVER

The Dover model has on the top, between the combustion chamber and the top (see
drawing D32), a ceramic thermal storage which allows the stove to radiate heat for a
longer time (even when the stove is switched off), increasing the thermal inertia of the
stove.
For its replacement, it is necessary to remove the top of the stove, so you have to remove
the 4 screws located on the top of the oven (see drawing D33) and then you will be able
to extract this ceramic piece or even increase the number of them, in order to raise the
power of thermal radiation (max 4 pieces).
2.1.7.

VALENCIA

This model has the smoke outlet in the rear (see drawing D34). In order to connect it, it will be
enough to connect to the outlet of the stove, a bend of 90° and then the rest of the extraction
pipes, always in vertical sections. Remember that horizontal pipe sections are not allowed.
It has a safety pin, so that when you place it in the top right side of your stove we can avoid a
fortuitous closure of the top of the stove, while using the "kitchen". (see drawing D35)
This model can be installed on the outside of the house. It has two wheels to place it anywhere you want and detachable handles that fit in
the back of the stove, to move it (see drawing D36).
For safety and comfort, we recommend moving the stove while it is cold and without the smoke pipe connected or installed.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D35
25
D31
D32
D33
D34
STOVES