Specifications According To The Model; Sydney-T And Louvre - Bronpi OXFORD Installation, Operating And Servicing Instructions

Kitchen
The Valencia model incorporates in the top part a hob with a lid for cooking. Heating is produced by
direct heat transfer.
The kitchen has a vitrified plate where you can directly place a kitchen pan for cooking the food. There,
you will find two of these plates (see drawing D17).
D18
In the models Oxford, Preston, Derby, Bury and Ordesa, to make the change of the collar
you have to follow the next steps:
4. First of all, remove the baffle plate.
5. Remove the vermiculite pieces (only model Oxford).
6. Later, screw out the cover and the collar, change their position and screw them
again in the new position (see drawing D19).
2.1.

SPECIFICATIONS ACCORDING TO THE MODEL

2.1.1.

SYDNEY-T AND LOUVRE

The models Sydney-T and Louvre have a 270 m
D20
the heat distribution by the ventilation.
The start and the control of the ventilation is made by the
regulator knob placed on the right back side of the stove (see
drawing D20).
This regulator has the following functions:
- OFF position: the fan is turned off when there is no combustion inside the chamber due to the stove is provided
with a thermostat that controls the fan according to the temperature of the stove.
- ON position: the fan is turned on although there is no combustion inside the chamber.
In any case, you can choose the fan speed by the regulator.
• TURBINE CONNECTION:
In the right back side of the stove you will find the cable that
connects to the electricity network.
It is advisable do not cut it in the entire length because this
section is useful when needed by changes in electrical
components inside.
It is obligated the correct connection of the installation to
earth connection.
The installation of the system might be done by skilled
labour and qualified under the current rules.
• REPLACEMENT OF THE TURBINE:
The replacement of any electrical component will be done
by the front of the stove. With this you do not have uninstall
the stove and you have to follow the next steps (see
drawing D21).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
Rear or top
smoke outlet
Some models
of stoves can
change the place of the smoke outlet collar because it
is easily removable, that allows to the installer a bigger
versatility when it is going to be installed.
In the model Etna, the smoke outlet collar can be
installed on the top or the rear of the stove. To make the
change of the collar we have to follow the next steps:
1. Remove the back sheet. For this you have to
screw out the 4 screws which links with the rear.
2. Screw out the screws of the baffle plate to
body.
3. Remove the baffle plate.
4. Later, screw out the cover and the collar,
change their position and screw them again in the new
position (see drawing D18).
3 /h fan to improve
23
D17
D19
D21
STOVES