ESAB Aristo Mig 3001i Service Manual page 67

f. Set the welding power souce to MMA-welding.
g. Set the welding current control on the welding power souce to maximum.
h. Check the voltage with the voltmeter.
S
Measured value shall not exceed 35 V.
i. Check that the LED indicates active VRD function by a steady green light.
j. Turn the mains switch of the the welding power source to OFF.
k. Disconnect the welding power source from the mains supply.
Test box TB 1
Circuit diagram of the TB 1
ca41_test - 67 -
S0740 800 196/E101019/P76