5. Option
5.1
Absolute Reset Jig
This jig is used to perform an absolute reset in the event that absolute data in the encoder was lost.
Model number
JG-2
For arm length 500/600
JG-3
For arm length 700/800
5.2
Flange
This flange is used to install a load at the end of the Z-axis arm.
Model number
IX-FL-1
For arm length 500/600
IX-FL-3
For arm length 700/800
5.3
Absolute Data Backup Battery
This battery is used to retain absolute data in the encoder. (Set the battery inside the cover of the SCARA robot.)
Model number
AB-3
For arm length 250 ~ 800
* Four batteries are needed for each robot (all
SCARA robot models). Since AB-3 batteries
are packed individually, specify the required
number in your order.
28
Remarks
Remarks
Remarks