Cushman Truckster XD 2018 Owner's Manual page 47

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
5. First operate accessories in a test area so that you completely understand the operation of the vehicle and controls.
6. Consider the area in which the vehicle will be operated, to determine appropriate vehicle settings and driving proce-
dures. The terrain and conditions of the surface determine necessary adjustments and precautions.
7. Do not allow people near the vehicle while in operation. The owner and operator are responsible for injuries caused
to people near the vehicle and damage to property.
8. Be careful when operating near gravel areas (roads, parking areas, cart paths). Stones released from the equipment
can cause injuries to people and damage to equipment.
9. Decrease speed and look for traffic before you cross or operate on paths or roads.
10. When you hit an object or the vehicle has a vibration that is not normal, inspect the vehicle for damage and make
necessary repairs.
11. Travel at decreased speed and be careful when you operate on slopes or near steep ledges.
12. When you drive in the reverse direction, look behind and down to make sure the path is clear. Use caution when you
go near corners, trees or other objects that can prevent a clear view.
13. Never use your hands to clean the accessories. Parts of the accessory can have sharp edges and can cause inju-
ries.
14. Use caution when pulling a load. Only use approved hitch points and pull loads in a controlled manner. Do not make
sharp turns. Use caution when you drive in the reverse direction. When recommended in the accessory manual, use
the wheel weights or counterweights.
Starting The Engine
1. Sit in the seat.
2. Put on the seatbelt.
3. Press the clutch pedal.
4. Engage the parking brake.
5. Remove your foot from the accelerator pedal.
6. Turn the ignition switch to the RUN position.
NOTICE: The warning lights on the instrument
panel will illuminate for a few seconds.
Make sure that the warning lights are illu-
minated.
Diesel Engine Option: When the glow plug light turns
off, immediately turn the ignition switch to the START
position. Release the key when the engine starts. Allow
30 seconds between start tries to allow the starter
motor to become cool.
Gasoline Engine Option: Turn the ignition switch to the START position. Release the key when the engine starts. Allow
30 seconds between start tries to allow the starter motor to become cool.
NOTICE: Do not hold the ignition switch in the START position for more than 10 seconds.
7. When the engine starts, all of the warning lights will turn off. Allow the engine to become warm before you operate
the vehicle.
Remove all objects you can find before operating the vehicle. Carefully
enter a new area and always operate at speeds that allow you to control
the vehicle safely.
Before you clean, adjust or repair this equipment, engage the parking
brake, stop the engine and remove the ignition key.
OPERATING PROCEDURES
Owner's Guide
Glow Plug
Light
Ignition
Switch
B
41