Cushman Truckster XD 2018 Owner's Manual page 39

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Turn Signal Switch
The turn signal switch is part of the optional turn signal accessory.
Press the left side of the switch to activate the left turn signal.
Press the right side of the switch to activate the right turn signal.
Return the switch to the center position to deactivate the turn signals.
Ignition Switch
The ignition switch has three positions, OFF, RUN and START.
High-Low Hydraulics Switch
The high-low hydraulic system switch is part of the high-low hydraulic system
option. The switch has three positions, OFF, HIGH and LOW. The high-low
switch must be in the OFF position to start the engine.
Press the top of the switch for the HIGH position to send the full flow of fluid
from the pump to the hydraulic accessory connections.
Put the switch in the LOW (center) position to send a decreased flow of fluid
from the pump to the hydraulic accessory connections.
Press the bottom of the switch for the OFF position to stop the flow of fluid to
the hydraulic accessory connections
Work Light Switch
The work light switch is part of the optional work light accessory.
The 12 Volt accessory outlet is protected by a 10-Amp fuse. Do not use
attachments with a power rating greater than 120 watts.
To prevent the risk of burns or fire, do not replace the 10-Amp fuse with a
fuse with a greater amperage rating.
OPERATING PROCEDURES
Owner's Guide
Left Turn
Signal OFF
OFF
RUN
HIGH
LOW
OFF
B
Right Turn
Signal
START
33