Cushman Truckster XD 2018 Owner's Manual page 41

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Governor Control
The governor control is part of the optional diesel speed control accessory.
The governor control decreases the engine governor RPM limits for the operation of the hand
and foot throttle.
Push the governor control completely to the top for maximum engine speed. Pull the lever
down to decrease maximum engine speed.
Set/Resume Switch
The set/resume switch is part of the gasoline speed control accessory. The operation of the
switch depends on the position of the stationary/cruise switch. See page 44 for operation
of the speed control system.
When the stationary/cruise switch is in the center position, the set/resume switch does not
function.
When the stationary/cruise switch is in the cruise control position, the cruise control speed
is set, increased or decreased with the set/resume switch.
When the stationary/cruise switch is in the stationary position, the engine speed is set,
increased or decreased with the set/resume switch.
Stationary/Cruise Switch
The stationary/cruise control switch is part of the optional gasoline speed control
accessory. See page 44 for operation of the speed control system.
Put the switch in the center position for normal operation of the vehicle. The engine
speed is controlled by the accelerator pedal.
Press the right side of the switch to the cruise control position to use the vehicle cruise
control. When the cruise control mode is active, the green light on the right side of the
switch will illuminate.
Press the left side of the switch to the stationary position to set the engine speed for use
with hand held hydraulic accessories. When the stationary mode is active, the green light on the left side of the switch will
illuminate.
OPERATING PROCEDURES
Owner's Guide
Fast
Slow
Set/ Resume/
Increase
Decrease
Stationary Cruise Control
Position Position
B
35