Interlock System; Operating Procedure - Cushman Truckster XD 2018 Owner's Manual

OPERATING PROCEDURES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

INTERLOCK SYSTEM

The Interlock System prevents the engine from starting unless the clutch pedal is completely pressed. If the optional
high-low hydraulic system is installed, the high-low switch must be in the OFF position for the engine to start.
Perform each of the following tests to make sure the Interlock System operates correctly. If any of the tests fail, stop the
test and have the system inspected and repaired as shown below:
• The engine does not start during test 1.
• The engine does start during test 2 or test 3.
Refer to the chart below for each test and follow the check (X) marks across the chart. Turn off the engine between each
test.
TEST 1: The test shows the normal engine start procedure. The operator is in the seat, parking brake is engaged, the
optional high-low switch is in the OFF position and the clutch pedal is completely pressed. The engine will start.
TEST 2: The engine must not start if the clutch pedal is not pressed.
TEST 3: The engine must not start if the optional high-low switch is in the LOW position or the HIGH position.
Test Operator Seated
1
2
3

OPERATING PROCEDURE

1. Always start the engine with the operator in the seat; never while next to the vehicle. Never start the engine with peo-
ple near the vehicle.
2. Never operate the engine in an enclosed or unventilated area. The carbon monoxide in the exhaust fumes can
increase to dangerous levels rapidly.
3. Keep hands and feet away from moving parts and accessories. When possible, do not adjust the vehicle with the
engine started.
4. Do not operate the vehicle with loose or damaged components. All components must be correctly fastened to the
vehicle. Operate when the grass is dry to get the best results.
40
Do not operate equipment with the Interlock System disconnected or the
system does not operate correctly. Do not disconnect or prevent the
operation of any switch.
Clutch Pedal
completely pressed
Yes No Yes
X X
X
X X
This vehicle has a Roll Over Protection Structure (ROPS). Always wear
the seat belt.
If the vehicle is over-turning, hold on to the steering wheel. Do not try to
move off the vehicle or leave the seat.
To prevent injury, always wear safety glasses, leather work shoes or
boots, a hard hat and ear protection.
High-Low switch in
the OFF position
No Yes
X
X X
Owner's Guide
Engine Starts
No Yes No
X
X
X X