Cushman Truckster XD 2018 Owner's Manual page 37

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
The amber hydraulic-level light indicates a low-fluid level in the hydraulic tank. Stop the vehicle immediately.
Visually inspect the vehicle for indications of leaks around connections, hoses and hydraulic components.
Return the vehicle to the service area for maintenance. The light will only function when the high-low
hydraulic system option is installed.
The red coolant temperature light indicates that coolant temperature is more than 230° F (110° C). Stop unit
immediately. Remove the tree leaves, grass clippings and other objects that can decrease air flow through
the radiator screen, oil cooler and the radiator. If the engine continues to run hot, return vehicle to the
service area.
The red engine oil pressure light indicates engine oil pressure is less than 7 psi (0.48 BAR). Immediately
stop the engine and inspect oil level in the engine. If the oil pressure light remains illuminated with the oil at
the correct level, stop the engine and tow the vehicle to the service area. NEVER operate the engine with the
oil pressure light illuminated or engine damage can occur.
The red parking brake light indicates that the parking brake is engaged. Do not press the accelerator pedal
with the light illuminated.
The amber glow plug light indicates that the glow plugs are active. Do not turn the ignition switch to the start
position until the glow plug light turns off.
The amber check engine light indicates that the gasoline engine controller has sensed a problem. Connect
the CAN diagnostic tool to identify the problem. The check engine light does not function with the diesel
engine option.
The amber fuel light indicates that the fuel tank is almost empty. Return the vehicle to the service area and fill
the tank before you continue to operate the vehicle.
The high beam indicator light does not function with this vehicle.
When the optional turn signal kit is installed and the turn signal switch is in the left turn position, the left-side
turn signal light will flash.
When the optional turn signal kit is installed and the turn signal switch is in the right turn position, the right-
side turn signal light will flash.
The hydraulic fluid is under pressure. To prevent injury, do not use your
hands to find hydraulic leaks, use paper or cardboard. Allow the hydrau-
lic fluid to become cool before you check the fluid level or you add fluid
to the hydraulic tank.
The engine coolant is under pressure. To prevent injury, do not remove
the radiator cap on a hot radiator.
OPERATING PROCEDURES
Owner's Guide
B
31