Figure 21 2.5'' Hdd Installation; Figure 22 2.5'' Hdd Installation - Chenbro RM245 Series User Manual

1. Engage two embossed pin into the side dimples on the HDD as shown
2. Carefully push down the rear side of HDD until another two embossed pin and side dimples lock into place
NOTE:
To ensure proper system air flow requirements, all front drive bays must be populated with a drive carrier. Drive carriers
must be installed with either a drive or supplied drive blank.
There are drive carriers to support 2.5" devices and 3.5" devices. To maintain system thermals, all drive bays must be populated with
a drive carrier mounted with a hard disk drive, SSD, or supplied drive blank. Drive blanks used with the 3.5" drive carrier can also be
used to mount a 2.5" SSD into it as shown below.

Figure 21 2.5'' HDD Installation

Figure 22 2.5'' HDD Installation

RM245 Series
/ Installation 24
│