Notes On Resetting The Hand-Held Scanners; Pairing With Base Station Doesn't Work - Bartec BCS 3600ex Series User Manual

Handscanner
BCS 3600 series
ex
11.2.3

Pairing with base station doesn't work

Subject to technical modifications
Revision A / 04/2019

Notes on resetting the hand-held scanners

When using the BCS 3678 Bluetooth version.
ex
When using "Set Factory Default" the following settings are not reset.
Multipoint-to-Point connection is not reset.
-
May have to be reset manually e.g. when updating the scanner firmware via Zebra 123
Scan Utility (only possible with activated point-to-point connection).
Existing pairing connections are not reset/deleted.
-
Must be done manually by using the barcode "Unpairing" in the Zebra "Product Reference
Guide".
When using "Set Factory Default" the following settings are reset.
When using the BCS 3678
-
the LED display to the Ex modifications.
Possible cause Hand-held scanner is already connected to another base station
Possible solution Unpair the hand-held scanner from the docking station or from the
PC/host to make the docking station available for pairing with another
digital device.
Scan the barcode below to disconnect all existing digital scanner
connections to docking station/PC host/other Bluetooth devices.
Unpairing
Further information on pairing methods can be found in the
corresponding Zebra "Product Reference Guide" in Chapter 4 - "Radio
Communication".
When "Factory Default Barcode" is scanned, all data is reset to factory settings but no existing
pairing connection is deleted.
-IS the barcode for the status LED has to be scanned to adapt
ex
11 Faults – causes and
remedies
99 / 106