Operation; General Operating Instructions; Initial Operation; Operating The Cooktop - bora PKT11 Operating And Installation Instructions

Operation

EN
6 Operation
Observe all safety and warning information during
X X
operation (see the Safety section).
INFO The cooktop may only be operated when the
stainless steel grease filter is installed (see
operating instructions for cooktop extractor).
INFO
Clean the grill zone before using the cooktop
for the first time (see the Cleaning section).
INFO
Preheat the grilling zone for 8-10 minutes
before it is used each time.
6.1

General operating instructions

The cooktop is controlled using the control knobs.
Each grill zone has its own control knob. The front grill
zone is controlled using the left-hand knob and the back
grill zone with the right-hand knob.
For each grill zone, there are 9 power levels, one power
setting and various functions available:
P
9
8
Fig. 6.1 Knob ring assignment
Knob ring position
0
c
1 - 9
P
t
Tab. 6.1 Knob ring positions
22
0
c
t
1
2
3
4
7 5
6
Function
Switching off
Cleaning function and other
temperature levels
Power levels
Power setting
Timer function
6.2

Initial operation

The following phenomena are not errors relating to the
grill plate; its function is in no way impaired by them:
Before using it for the first time, heat the grill zones
Q Q
up to 220 °C (= power level 8) for approx. 25 minutes.
Disturbing odours may occur during this process.
When grilling or heating up the grill zone to the
Q Q
maximum setting, the stainless steel plate will turn
slightly brown.
If the grill plate is used frequently, the grilling surface
Q Q
may bulge slightly in the middle over the central zone
division.
6.3

Operating the cooktop

6.3.1 Switch on the grilling zone

Fig. 6.2 Switch on the grilling zone
Turn the knob ring from the 12 o-clock position to a
X X
power level.
Adjusting the power level
Turn the knob ring to the desired power level
X X
(temperature).
The control knob display shows the set temperature
Q Q
for 3 seconds. It then shows the actual temperature,
with the display flashing as it heats up.
The display stops flashing as soon as the set
Q Q
temperature is reached.
While it is heating up, you can press the touch surface
X X
for 1 second to display the set temperature.
www.bora.com