Flush Installation; Surface Mounting; Installing The Cooktop - bora PKT11 Operating And Installation Instructions

Please note the worktop overhang x when creating
X X
the worktop cut-out. Applies to flush installation and

surface mounting.

5.4.2 Flush installation

A ±2
B ±2
Fig. 5.3 Flush installation
Fig. 5.4 Groove dimensions for flush installation
5.4.3 Surface mounting
B ±2
Fig. 5.5 Surface mounting
www.bora.com
14
Fig. 5.6 Surface mounting cut-out
Cut-out dimensions when installing cooktops or cooktops
and the cooktop extractor next to each other:
Cooktops/cooktop extractor
1/0
2/0
3/0
1/1
2/1
3/2
4/2
Tab. 5.2 Cut-out dimensions
5.5

Installing the cooktop

INFO
Clearance of one millimetre should be planned
between the built-in appliances.
INFO A clearance of two millimetres should be
planned around the built-in appliances.
INFO A mounting rail must always be fitted between
adjacent cooktops (available as an accessory).
INFO Alternatively, the cooktop can be fitted rotated
about 180°.
Cross bars on the kitchen unit in the area of the
Q Q
worktop cut-out may need to be removed.
The drawers and/or shelves in the floor unit must be
Q Q
removable for maintenance and cleaning purposes.
Make sure that the area below the cooktop is
X X
sufficiently ventilated.
Installation
(12)
A in mm B in mm
374 346
745 717
1116 1088
485 457
856 828
1338 1310
1709 1681
EN
15