Optional Cable Protection; Installing The Control Knob Into The Floor Unit Front Panel - bora PKT11 Operating And Installation Instructions

Installation
EN
INFO A minimum opening cross section of 50 cm²
must be provided for ventilation on the front
side and in the false floor.

5.5.1 Optional cable protection

If cable protection (false floor) is planned below the
device, this must be fitted so it can be removed for
maintenance work. Sufficient ventilation or extraction
must be guaranteed.
Fig. 5.7 Side view of cable protection
5.5.2 Installing the control knob into the
floor unit front panel
INFO Pre-drill the bore holes to prevent tearing out
the fixed front panel.
Fig. 5.8 Installed control knob and cooktop
16
Fig. 5.9
100 [1]
[2]
[3]
Fig. 5.10
X
X
X
X
X
X
X
370
≥70
80-140
Drill template
Cooktop
Worktop
Floor unit panel
Fitting the control knob
Pull off the knob ring.
X
Unscrew the fixing nut.
X
Push the control knob through the drilled hole in the
X
floor unit panel from the front.
Screw the fixing nut onto the control knob from the
X
rear and tighten a little.
Use the marking to align the control knob vertically in
X
the 12 o'clock position.
Tighten the fixing nut.
X
Place the knob ring on the control knob.
X
www.bora.com