Seal The Cooktop; Establish Communication - bora PKT11 Operating And Installation Instructions

Installation
EN
If applicable, insert the height adjustment plates [2].
X X
2
1
Fig. 5.15 Mounting brackets
[1]
Screw
[2]
Mounting bracket
Fasten the cooktop [1] using the mounting brackets
X X
[2].
Tighten the mounting bracket screws [1] with max.
X X
10 Nm.
Verify that the alignment is correct.
X X
Once all of the installation work is complete, seal the
X X
devices with black, heat-resistant silicone sealant.
Installation rotated around 180°.
Rotate the cooktop around 180°.
X X
For the installation, proceed as described above.
X X
Change the installation direction in the configuration
X X
menu (see Configuration menu).
INFO
If installation is rotated around 180°, then
the connections for the control knob and the
extraction system are at the rear.
INFO If installation is rotated around 180°, then
the connections for the control knob and the
extraction system are at the front.
INFO
Cables of sufficient length are supplied.
18

5.5.4 Seal the cooktop

Make sure that no silicone sealant gets under the
X X
cooktop.
1
Fig. 5.16 Silicone sealant for flush installation
[1]
Black, heat-resistant silicone sealant
1
Fig. 5.17 Silicone sealant for surface mounting
[1]
Black, heat-resistant silicone sealant

5.5.5 Establish communication

Establish the connection between the cooktop and the
X X
control knobs.
Connection the control knob
1
Fig. 5.18 Connection the control knob on the back
[1]
Connection the control knob on the back
www.bora.com