Installation; Checking The Scope Of Delivery; Tool And Aids; Assembly Instructions - bora PKT11 Operating And Installation Instructions

Installation

EN
5 Installation
Observe all safety and warning information
X X
(see the Safety section).
Follow the enclosed manufacturer's information.
X X
INFO The cooktop must not be installed above
cooling devices, dishwashers, stoves, baking
ovens, washing machines or driers.
INFO The contact surface of the worktops and wall
sealing strips must be made of a heat-resistant
material (up to approx. 100 °C).
INFO Worktop cut-outs must be moisture-sealed
using suitable means or, where necessary,
fitted with a thermal insulator.
5.1

Checking the scope of delivery

Name
Control knob
Operating and installation instructions
Cooktop fixing screws
Height adjustment plate set
Cooktop
Cooktop mounting straps
Control knob cable
Automatic extraction cable
Tepan scraper
Tab. 5.1 Scope of delivery
Check the scope of delivery for damage and make sure
X X
it is complete.
If there are any missing or damaged parts, please
X X
notify BORA After Sales Service immediately.
Do not under any circumstances install parts which are
X X
damaged.
Dispose of transport packaging in the proper manner
X X
(see the Decommissioning and Disposal section).
5.2

Tool and aids

The following tools are required for the correct installation
of the cooktop:
Pencil
Q Q
Measurement equipment:
Q Q
Drill or cordless drill with Forstner bit Ø 50mm
Q Q
Screwdriver/hexolobular internal key (Torx) 20
Q Q
Silicone sealant for sealing cutting surfaces
Q Q
14
5.3

Assembly instructions

5.3.1 Safety clearances

Maintain the following safety clearances:
X X
3
Fig. 5.1 Minimum clearances
Quantity
[1]
Minimum clearance of 50 mm at the back from of the
2
worktop cut-out to the rear edge of the wor0°).
1
[2] Minimum clearance of 50 mm from the left and right
4
of the worktop cut-out to the adjacent cabinet or
wall. For ergonomic reasons and to ensure efficient
1
cooktop extraction, a minimum clearance of 300 mm is
1
recommended.
4
[3] Minimum clearance of 600 mm between the worktop and
2
the wall unit.
1
1
5.4

Cut-out dimensions

Preparing the worktop
Create the worktop cut-out taking into account the
X X
specified cut-out dimensions.
Make sure that the cutting surfaces of the worktops
X X
are properly sealed.
Comply with the instructions of the worktop
X X
manufacturer.

5.4.1 Worktop overhang

Fig. 5.2 Worktop overhang
2
x ≥74
1
www.bora.com