Table of Contents
Advertisement
Securing the Tepan stainless steel grill PKT3
2 1
4
Fig. 5.18
Mounting brackets
[1]
Mounting bracket
[2]
Washer
[3]
Screw
[4]
Screw (60 mm)
Secure the appliance using the mounting brackets [1].
X
X
Tighten the mounting brackets with the screws [3] and [4]
X
X
using the washer [2] with max. 2 Nm.
Verify that the alignment is correct.
X
X
5.7.2 Installation rotated by 180°
(alternative installation variation)
Installation rotated by 180°
Rotate the cooktop 180°.
X
X
For the installation, proceed as described above.
X
X
Change the installation direction in the configuration menu
X
X
(see "Configuration menu").
i
If installation is rotated by 180°, then on the Tepan
stainless steel grill PKT3 the ports for the control knobs
and the automatic extractor function are at the front.
i
Cables of sufficient length are provided.
5.8
Establishing communication and
power connection
Observe all safety and warning information (see the "Safety"
X
X
chapter).
The plug for the power supply must be accessible following
O
X
installation.
If the power supply cable has been damaged this must be replaced.
O
X
i
The appliance components are linked by the ribbon cable
provided.
www.bora.com
2
3
5.8.1 Connecting the control knobs
i
Control knobs must only be connected to the ports
provided on the appliance.
1
Fig. 5.19
Back of control knob with port
[1]
Port on the back of the control knob
Connect the control knobs to the appliances.
X
X
Connecting the control knobs to the cooktop
i
In the normal set-up the ports are on the back of the
Tepan stainless steel grill PKT3.
i
According to the default settings, the left control knob
operates the front cooking zone (zone 1) and the right
control knob operates the rear cooking zone (zone 2).
1
2
ZONE1 INTERF. COM1 ZONE2
Fig. 5.20
Control knob port at the rear of the cooktop
[1]
Front cooking zone control knob port (zone 1)
[2]
Extractor electronics interface port
[3]
Rear cooking zone control knob port (zone 2)
Installation
EN
3
19
Advertisement
Table of Contents
