Motor Replacement; Microswitch Replacement - Pentair Siata V132 SFE Installer Manual

Table of Contents

Advertisement

Installer manual Siata V132 - SFE - Maintenance

9.2.3. Motor replacement

No.
A
Using a screwdriver, unscrew the screw (9).
B
Remove the controller (6) from the valve (8).
C
Using a screwdriver, unscrew the four screws (1).
D
Remove the front panel (2) from the controller (6).
E
Using a screwdriver, unscrew the two screws (10).
F
Remove the motor (5).
G
Remove the pinion (3) and check the condition of the spring (4).
H
If necessary, unscrew and change the spring (4) using pliers.
Using a plastic screwdriver, unscrew the four screws (12) to access the electronic
I
board (11).
J
If necessary, disconnect the three connectors (14) and replace the motor (5).
A
Note
Pay attention to the connector order.
K
Reverse above procedure steps to rebuild.

9.2.4. Microswitch replacement

No.
A
Using a screwdriver, unscrew the screw (9).
B
Remove the controller (6) from the valve (8).
C
Using a screwdriver, unscrew the four screws (1).
D
Remove the front panel (2) from the controller (6).
Using a plastic screwdriver, unscrew the four screws (12) to access to the electronic
E
board (11).
F
Using a plastic flat screwdriver, disconnect the microswitch cable (13).
G
Disconnect the connectors (7) and change the microswitch.
H
Reverse above procedure steps to rebuild.
60 / 88
Operation
Operation
Ref. MKT-IM-003 / B - 19.04.2017

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Siata v132 sfe

Table of Contents