Table of Contents
Advertisement
Installer manual Siata V132 - SFE - Installation
5.
Installation
A
Caution
It is strictly forbidden for non-qualified persons to access the system's internal components
in order to perform any kind of technical operation.
5.1.
Warnings
The manufacturer will not be held liable for any damage or injury to persons or property resulting
from improper use of the device, or use not in line with the following instructions.
Should this guide leave any doubt concerning installation, service or maintenance, please contact the
technical support of the company that installed the device.
Device installation must be done by a qualified technician according to the current standards and
regulations, using tools approved for use with safety devices and the same technician must perform
maintenance on the device.
In the event of breakdowns or malfunctions, before performing any kind of action on the device, make
sure the transformer is disconnected from the power source, the water supply to the valve inlet shut
off and the water pressure drained by opening a tap downstream of the valve.
5.2.
Safety notices for installation
•
Observe all warnings that appear in this manual;
•
Only qualified and professional personnel are authorized to carry out installation work.
5.3.
Installation environment
5.3.1. Tips and suggestions
Connection of pipes and fittings
Where 1/8" GAS rigid pipes or hoses are used in connections between pipes and fittings (diameter of
approximately 9.7 mm), take care to respect the pipe dimensions. Pipes of a smaller diameter do not
guarantee a pressure/vacuum seal. Pipes of a larger diameter, conversely, must be forced into their
housing and this adversely affects the installation of retaining rings (3) and (4) resulting in a poor seal.
When working on fittings that are already installed, always replace retaining rings (3) and (4) 65-AC
and 65-AA with equivalent new parts. When installing, ensure that the end of pipe (1) fully enters the
housing of fitting (5) to ensure maximum grip. If a flexible tube is used, tighten pipe collar (2)
thoroughly by hand. If a rigid pipe is used, tighten ring (2) using a wrench.
32 / 88
Ref. MKT-IM-003 / B - 19.04.2017
Hide quick links:
Advertisement
Table of Contents
